home contact My Account cart
Testimonials FAQ and Knowledge Base product search:

Knowledgebase Home | Glossary | Favorites | Contact Knowledgebase Home | Glossary | Favorites | Contact
Search the Knowledgebase Browse by Category

[Advanced Search]
Point to Point Network using Netgear WG102 APs
Would you like to...
Print this pagePrint this page
Email this pageEmail this page
Post a commentPost a comment
Subscribe me
Remove from favoritesRemove from favorites
I have two Netgear WG102 APs that I want to run in PTP bridge mode. According to Netgear they use RP-SMA connectors.  What do you have that will work.

You will need the following for each AP:

A pigtail to adapt the RP-SMA connector to a standard N connector:

http://www.jefatech.com/product/195RPSMANM24

A low loss jumper cable (N Male to N Female and the length you need from the AP to the antenna):
http://www.jefatech.com/product/ll400

A directional antenna.  Any of these will work fine.  If it is very long or has obstructions, I recommend the 24dBi grid.  Otherwise, any of the smaller antennas will work fine:

http://www.jefatech.com/category/a130/

Antenna mount (two options):
http://www.jefatech.com/product/UM
http://www.jefatech.com/product/WMB
Related Questions
Attachments
No attachments were found.

Powered by ActiveKB Knowledgebase Software